TEXA CNH Group Bridged Connector for HH Menu
Case New Holland (CNH) Industrial is one of the world’s largest equipment manufacturers, their brands include Case IH, Steyr, Case Construction Equipment, New Holland Agriculture, New Holland Construction, Iveco, Astra, Iveco Bus, Heuliez Bus, Magirus, Iveco Defence Vehicles, and FPT Industrial.
The CNH Group Bridged Connector is used to place the instrument panel into diagnostic mode. Start with the vehicle off then insert the CNH Bridged Connector is inserted into the diagnostic port, turn the key on and the instrument panel will report the number and status of controllers on the Control Area Network (CAN).
Functions available within the HH Menu include:
- Calibration procedures
- View calibration values
- Configurations
- View software revision levels
- Switch operation test
- View vehicle information
- Vehicle test modes
- Clear stored calibration information
- Voltmeter diagnostics
- Demonstration mode
- Display stored fault codes
- Clear all fault codes
- Transmission setup
- Display frequency inputs
- View controller hardware information
- Electronic hydraulic remote control valve setup